PLM-TH 6-Axis CNC Spring Coiling Machine

PLM-TH is a 6-axis CNC spring coiling machine with a listed wire diameter range of 1.0–4.5 mm and a maximum spring outside diameter of 65 mm. Discuss spring production for spin-on oil filters or other industrial products using your wire specification and spring drawing.

• Six-axis configuration: Servo axes cover wire feeding, pitch control, outside-diameter adjustment and cutting.
• Define the complete spring: Review wire grade, wire diameter, finished outside diameter, free length, coil count, pitch and end requirements together.
• Match tooling to the product: Confirm the tooling and setup needed for the intended spring family and production plan.
• Check output on the specified part: The quoted maximum rate is a reference limit; verify achievable output using the proposed spring, material and setup.

Spin-On Filter Springs

Review coil springs for selected spin-on oil and fuel filter designs. Confirm the spring geometry, end requirements, fit in the assembly and required spring characteristics against an approved drawing or sample.

Other Industrial Compression Springs

Discuss compression-spring requirements for automotive components, mechanical assemblies, appliances and hardware. Manufacturing scope is assessed from the actual wire material, finished geometry and tooling requirements; an industry name alone does not establish suitability.

Production demonstration. Settings and output depend on the specified spring and material.

Can the machine make springs for products other than filters?

Other industrial compression-spring projects can be reviewed against the wire material, dimensions, end requirements and tooling. Submit a drawing and representative sample before confirming the manufacturing scope.

Does every spring run at 180 pcs/min?

180 pcs/min is the quoted maximum rate. Achievable output depends on the spring design, wire material and operating setup and must be confirmed for the specified part.

What about end grinding, heat treatment and testing?

Confirm the complete process and supply scope for the intended spring. Any required downstream treatment, grinding or testing should be identified separately in the technical offer.

Share the wire grade and diameter, spring drawing, outside diameter, free length, coil count, pitch, end configuration, target output and local power supply. Include sample photos and the required force or load information where available.

Request a spring sample review