PLJY109-500A Spiral Expanded Metal Tube Forming Machine

PLJY109-500A spiral expanded metal tube forming machine
Built around your filter design.

Match the machine, metal coil and tooling for cylindrical air filter support tubes.

  • 80–450 mm tube diameter range | 3.15–17.72 in
  • 109 mm nominal mesh strip width | 4.29 in
  • Machine, coil and tooling matching
  • Pre-shipment material trial planning
Built for cylindrical air filter support tubes

For inner support and outer protective tubes in cylindrical air filters. Start with the finished tube requirements, then define the forming process.

Close-up of a spiral-formed expanded metal support tube for air filters.

Spiral-formed expanded metal support tube for cylindrical air filters.

Consistency where it matters.

Define diameter, roundness, cut length and seam condition against your tube drawing. Include edge checks where metal contacts the filter media.

Make changeovers measurable.

Map the tooling and adjustment steps for your product mix. Measure changeover from the last acceptable tube to the first acceptable tube of the next size.

Give operators a clear starting point.

Request documented settings, approved samples and first-piece inspection checks for the configurations agreed in your order.

Watch the forming process

Product demonstration; operating results depend on the specified material and setup.

Additional forming demonstration: Watch on YouTube

Specification
Product Name PLJY109-500A
Diameter Range 80–450 mm
Net Width 109 mm
Net Thickness 0.4–0.8 mm
Min. Length of Roll Net 170 mm
Production Capacity 54 m
Total Power 4 kW
Working Air Pressure 0.6 MPa
Power Supply 380 V / 50 Hz
M/C Weight 900 kg
M/C Size (L × W × H) 1450 × 1050 × 1600 mm
Engineering details to confirm

Confirm tube OD / ID, base-metal versus overall mesh thickness, tooling coverage, material grade, tolerances and electrical requirements for your application. Published range endpoints do not establish every possible material-and-diameter combination.

Production-rate units and the measurement basis require confirmation for the quoted configuration.

Specify the machine. Match the first batch.

Coordinate equipment, metal supply and an acceptance plan around the filter you need to manufacture.

Start with the right coil.

Review strip width, stock thickness, opening geometry, surface condition and material grade with the forming setup.

Plan a material trial.

Request a material trial plan. Availability, test conditions and acceptance limits are subject to agreement.

  • Dimensional, seam and edge checks
  • Accepted output, scrap and stoppage records
  • Changeover timing and approved setup references

Plan one coordinated shipment.

Review machine crates and protected coil pallets together. Discuss filter paper, end caps and adhesives for your downstream process where required. Confirm the supply scope and shipping arrangement in your quotation.

Engineering FAQ

What tooling do I need for different tube diameters?

Start with your tube drawing, mesh specification and size range. Confirm the tooling required for each size. The published diameter range does not establish that one tooling setup covers every size.

Can it run on 480 V / 60 Hz?

The published supply is 380 V / 50 Hz. Specify your voltage, frequency and phase for review. Alternative configurations require technical review and confirmation.

Can my existing expanded metal be tested?

Discuss a trial using your proposed coil specification or a representative sample. Trial availability, test conditions and acceptance limits are subject to agreement.

Plan your tube-forming setup

Share your tube dimensions, material, required output, factory power supply and destination country with PLM. Include drawings or sample photos where available.

Discuss my machine and material configuration

Downloads

To protect the documents privacy, please contact us to get the download password: [email protected]